Installation Guide- How to Fit Friction Stay Window Hinges

This comprehensive installation guide will provide step-by-step instructions on how to fit friction stay window hinges, ensuring a secure and smooth operation. Whether you’re a seasoned DIY enthusiast or a novice tackling your first window hinge installation project, this guide will empower you to complete the task successfully.

Materials Required

Friction stay hinges

Screws

Screwdriver or drill

Marking pen or pencil

Tape measure

Level

Step 1: Prepare the Window Frame

Remove the existing casement or sash window.

Mark the positions for the hinge plates on the window frame and the casement.

Ensure that the hinge pins align vertically when the window is closed.

Step 2: Fix the Hinge Plates

Using a screwdriver or drill, screw the lower hinge plate onto the window frame.

Align the hinge pin of the upper hinge plate with the pin on the lower hinge plate.

Secure the upper hinge plate onto the casement.

Step 3: Install the Hinge Arms

Insert the hinge arm of the lower hinge plate into the slotted hole on the casement.

Ensure that the hinge arm is fully engaged and that there is no play or movement.

Repeat this step for the hinge arm of the upper hinge plate.

Step 4: Adjust the Friction

Locate the friction adjustment screw on the hinge plate.

Use a screwdriver or Allen key to turn the adjustment screw clockwise to increase the friction, making it harder to open the window.

Turn counterclockwise to decrease the friction, making it easier to open.

Step 5: Reinstall the Window

Carefully lift the window into position and align it with the hinges.

Swing the window open and closed several times to ensure smooth operation.

If necessary, adjust the friction again until you achieve the desired resistance.

Step 6: Secure the Window

Close the window and check if it stays closed without any excessive rattling or movement.

If necessary, slightly tighten the screws on the hinge plates to secure the window further.

Tips

Use the level to ensure that the hinge plates are installed straight.

Apply a small amount of lubricant to the hinge pins to prevent squeaking.

Avoid overtightening the screws, as this could damage the hinges or the window frame.